[EMAIL PROTECTED] wrote:
> Sebastian, et al
>
> I built the latest hostmot2 drivers from source. Unfortunately where the
> machine
> is does not have an internet connecton, nor are the development tools loaded
> on
> the target system, so I compiled on my development system. I then copied the
> files hm2_5i20.ko and hostmot2.ko to the target machine. This of course could
> be
> the problem, although it is very close to working.
>
> They seem to load and run, as I noticed the stepper paramters (step length,
> etc.) were changed from floats to U32s. I patched the hal file for that and
> everything loads without error.
>
> What I get is, the PWM gives some output, but does not seem to be changing (I
> don't have a scope connected) or at least doesn't change much. Additionally
> the
> two stepper motors don't seem to be working at all. The GPIO however seems to
> work fine.
>
> Any ideas? Are there any other files I need to copy over to the target system?
I would suggest you compile the CVS TRUNK to emc2.deb on your
development machine and install the .deb on your CNC machine.
Also, please pastebin the machine config files you're using.
--
Sebastian Kuzminsky
Theo: "Julian? I haven't seen you in twenty years. You look good.
The picture the police have of you doesn't do you justice."
Julian: "What do the police know about justice?"
-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
