I was wondering why you wouldn't have the spindle/coolant/tool selection etc start automatically when resuming? Or do you mean it does but you can also change these things and resume?
Chris Morley ---------------------------------------- > Date: Thu, 9 Oct 2008 09:28:07 -0500 > From: [EMAIL PROTECTED] > To: emc-users@lists.sourceforge.net > Subject: [Emc-users] run from line / program restart > > I committed some changes to TRUNK that let you load a tool, set > tool offset, turn on the spindle, turn on coolant, etc., in MDI or > manual mode, and then resume in the middle of a program. > > Previously, resuming the program reset some of the machine setup > including turning off the coolant. > > Also, Jeff committed some changes to AXIS making resume easier to use. > After aborting a program, the motion line that was currently running > now stays highlighted. You can right click on it to resume from > there, or if that's not a good place to resume, it helps you know > where to look to find a nearby move that's a good place. > > If you have been unhappy with resume, please try these changes. > > > ------------------------------------------------------------------------- > This SF.Net email is sponsored by the Moblin Your Move Developer's challenge > Build the coolest Linux based applications with Moblin SDK & win great prizes > Grand prize is a trip for two to an Open Source event anywhere in the world > http://moblin-contest.org/redirect.php?banner_id=100&url=/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _________________________________________________________________ ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users