No limit switches. Where do I find the "step config" ? Was that part of the machine config I set up originally through the config wizard?
John -----Original Message----- From: Jeff Epler [mailto:[EMAIL PROTECTED] Sent: Wednesday, October 15, 2008 11:26 PM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] EMC2 and the Sherline mill Do you have limit switches? If you do not, then remove the configuration for limit switches. In stepconf, this means setting the pin setup to "unused" for pins which are currently listed as "limit" of one kind or another. If you do, verify that they are hooked up as you intended. Use halmeter (Machine > Halmeter menu item in axis) to verify the value seen by emc for the corresponding signal is what is expected (TRUE for switch closed, FALSE for switch open). If the value does not change when the limit switch closes, then verify the wiring again. If it does, but it TRUE for switch open, FALSE for switch closed, then change your configuration to use the inverted output. This means turning on the corresponding "invert" checkbox in the parallel port configuration screen of stepconf. Jeff ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
