I am currently running emc 2.2.6 I
have been threading a right hand M10x1.25 thread all day
approximately 90 parts. I switched to cutting a left hand M10x1.25
and everything was fine for the first 20 parts then suddenly on the
spring back pass it will rapid one of the cuts. I looked at the
wires on the spindle encoder to see if anything got loose and all
looked fine. Ran the same code again with no problems, thought it
was a fluke and continued to run parts. Four parts later it did the
same rapid still on a spring pass but the last one not the first.
Ran the program ten times in the air and 4 times it ran perfectly 6
times it rapided in a spring pass, always a spring pass. I switched
back to right hand cuts and it ran without issue.
Ideas?
Thanks,
Richard
-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
