On Dec 2, 2008, at 9:26 PM, Stephen Wille Padnos wrote: > Dave Engvall wrote: > >> Hi all, >> >> IIUC there is no way to dynamically replace a whole tool table. >> IOW I must shut down emc, edit the .ini to point to the new tool >> table and then start emc again. >> >> > I'm pretty sure you can reload the tool table. If this is so, then > you > can replace the contents even if you can't change the name of the > table > that gets loaded. > > - Steve >
My intent was to change the name of the tool table to reflect the special job I needed it for. Otherwise I can just use cp to overwrite the old table after stashing it someplace safe. To change the name we need a way to force binding of the new name and that probably isn't possible in a simple way. Dave > > ---------------------------------------------------------------------- > --- > This SF.Net email is sponsored by the Moblin Your Move Developer's > challenge > Build the coolest Linux based applications with Moblin SDK & win > great prizes > Grand prize is a trip for two to an Open Source event anywhere in > the world > http://moblin-contest.org/redirect.php?banner_id=100&url=/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
