You can home again.. It's true you can't travel 80 to go to the correct location, but you should be able to do it in 2 steps.. Go to 40 home again, go to 0 home again. In the upcoming 2.3, I think there is an "unhome" ability.
Regards, Alex ----- Original Message ----- From: "Lars Andersson" <l...@larsandersson.com> To: "'Enhanced Machine Controller (EMC)'" <emc-users@lists.sourceforge.net> Sent: Sunday, April 12, 2009 12:44 PM Subject: [Emc-users] Undo manual home > Hi list, > I am temporarily running my mill without a home switch on Z axis. > Travel is set to -4 , 70 > In AXIS, if I accidentaly press "home" in the wrong place, say 80, how can > I > jog past my incorrect home position towards the real home at 0? > The only way I have found so far is to restart AXIS. > > > > > ------------------------------------------------------------------------------ > This SF.net email is sponsored by: > High Quality Requirements in a Collaborative Environment. > Download a free trial of Rational Requirements Composer Now! > http://p.sf.net/sfu/www-ibm-com > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG - www.avg.com Version: 8.5.287 / Virus Database: 270.11.53/2054 - Release Date: 04/11/09 10:51:00 ------------------------------------------------------------------------------ This SF.net email is sponsored by: High Quality Requirements in a Collaborative Environment. Download a free trial of Rational Requirements Composer Now! http://p.sf.net/sfu/www-ibm-com _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
