Here are some common causes of following error with steppers http://www.linuxcnc.org/docview/html//common_Stepper_Diagnostics.html#r1_2_1
On 6 May 2009 at 10:44, Michael Jones wrote: > I'm getting a "joint following error on axis 0" EMC2 2.3 lately. > This > usually happens when doing some fine detail an engraving with a fine > v > bit - and of course when it's about 90% done with the program.. I > haven't been doing this long enough to say that it's definitely 2.3 > as > I didn't get my engraving programs set up until after I upgraded. > > What causes this type of error? > > - Michael > > -------------------------------------------------------------------- > ---------- > The NEW KODAK i700 Series Scanners deliver under ANY circumstances! > Your > production scanning environment may not be a perfect world - but > thanks to > Kodak, there's a perfect scanner to get the job done! With the NEW > KODAK i700 > Series Scanner you'll get full speed at 300 dpi even with all image > processing features enabled. http://p.sf.net/sfu/kodak-com > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ The NEW KODAK i700 Series Scanners deliver under ANY circumstances! Your production scanning environment may not be a perfect world - but thanks to Kodak, there's a perfect scanner to get the job done! With the NEW KODAK i700 Series Scanner you'll get full speed at 300 dpi even with all image processing features enabled. http://p.sf.net/sfu/kodak-com _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
