Classicladder does modbus too. Sent from my BlackBerry device on the Rogers Wireless Network
-----Original Message----- From: Mario - Promm <[email protected]> Date: Wed, 21 Jul 2010 11:27:33 To: <[email protected]> Reply-To: "Enhanced Machine Controller \(EMC\)" <[email protected]> Subject: [Emc-users] Spindle configuration Hi, I' m installing EMC in a 3 axis mill using the parallel port. I having difficulties with the control of the spindle. My machine uses a WEG (CFW-08) vfd which has serial and modbus communications. I wrote a C program to control the vfd using the serial port and its OK, but it runs in a terminal window. I'm studding the GS2 VFD HAL component in the hope I could modify it for the WEG vfd, but its complex to me. The other options could be use the WEG 0-10 V input or its electronic potentiometer (one pin that increase rpm and other that decrease). It hasn't a PWM input. I would appreciate any suggestions. Thanks Mario ------------------------------------------------------------------------------ This SF.net email is sponsored by Sprint What will you do first with EVO, the first 4G phone? Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ This SF.net email is sponsored by Sprint What will you do first with EVO, the first 4G phone? Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
