> I elected to use the "prob_rfx2" firmware version which is meant for the
> "generic" breakout board.
>
> The idea was to install the 5i25, hook my parallel cable from the printer
> port into the 5i25 and set up a new emc2 config.
>
>
> I'm a bit shaky on how to configure this as I just started studying it last
> night, however it appears to me that if I created a "prob_rfx2.xml" file,
> that I could utilize
> pncconf to build my emc2 configuration.
>
> I have the prob_rfx2.pin file that describes all of the pins that the
> firmware defines.
>
>
> Am I on the right track here? Also are there any references or tips that
> anyone is aware of to help me along?
>
> I'm linux savvy and a programmer, so any work that could be reusable I'd
> like to share and provide for others that may follow down this path.
>
I took a look at the firmware you quoted.
Yes if you make an XML file PNCconf will help you configure it.
I'll try to find time to build one these weekend.
Chris M
------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
