On Tuesday, March 13, 2012 08:34:52 PM Dave did opine: > FWIW, > > Yesterday, on the DIY-CNC forum a user reported a broken pipes error > while running the LinuxCNC Stepper Configuration software. I checked on > the IRC and a fellow said he saw that error occur when he was running > the latency test at the same time. The guy on the DIY-CNC forum said > that was the problem that was causing the broken pipes error on his > system. > Latency-test had not been started by me, it was started by stepconfig, but I closed it when I realized I hadn't yet turned off hyperthreading in the bios.
So it shouldn't have been running. One thing I haven't found yet, perhaps it isn't even installed, is where to start sshd. I've limp out and check on both as I haven't installed gkrellm yet either. > Dave > > On 3/13/2012 4:22 PM, gene heskett wrote: > > Hi all; > > > > I just ran thru stepconfig and tired to set up for a lathe, but > > without anything hooked to the parport. > > > > When it was time to exercise the axis, it couldn't, broken pipe > > errors. So I just ran the rest of the way thru it& saved it. > > > > Then, when I ran it from the created icon, all the limits were wrong, > > no move possible and I had to fix those in the .ini with gvim. > > Looking good, with the z running from -.01 on the left to 12" on the > > right, and the diameter/radius looking good too, I loaded up the pawn > > file from examples. It is displayed as if zero is on the right limit, > > and the diameter is all above a radius of zero. > > > > If I rotated axis 180 degrees, or better yet, changed the sign of all > > the values in that file, then it looks as if it fits my vision of how > > this should look. If I rotate axis 180, then the arrow keys are > > backwards. > > > > Call this newbie to a lathe in axis confused... So which is correct? No comment on this, guys? > > Thanks. > > > > Cheers, Gene > > ------------------------------------------------------------------------ > ------ Virtualization & Cloud Management Using Capacity Planning > Cloud computing makes use of virtualization - but cloud computing > also focuses on allowing computing to be delivered as a service. > http://www.accelacomm.com/jaw/sfnl/114/51521223/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users Cheers, Gene -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) My web page: <http://coyoteden.dyndns-free.com:85/gene> "Are [Linux users] lemmings collectively jumping off of the cliff of reliable, well-engineered commercial software?" (By Matt Welsh) ------------------------------------------------------------------------------ Virtualization & Cloud Management Using Capacity Planning Cloud computing makes use of virtualization - but cloud computing also focuses on allowing computing to be delivered as a service. http://www.accelacomm.com/jaw/sfnl/114/51521223/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
