Silly little HAL question if I may (I have RTFM and Googled but not
found an obvious answer).
Can you 'connect' two pins to the same signal without using or2 ?
I managed to configure two buttons on my pendant to do an estop but had
to use an or2.... which is a bit clunky.
I was just playing with the pyvcp examples and added the jog buttons but
linuxcnc errors out with:
>Starting LinuxCNC...
>custom_postgui.hal:35: Signal 'jog-minus-x' can not add OUT pin
>'pyvcp.x-minus', it already has OUT pin 'xhc-hb04.jog.minus-x'
>Shutting down and cleaning up LinuxCNC...
It's not a huge problem to use or2 but I thought I'd ask to see if I'm
missing a trick.
TIA.
--
Regards,
Russell
--------------------------------------------------------------------
| Russell Brown | MAIL: [email protected] PHONE: 01780 471800 |
| Lady Lodge Systems | WWW Work: http://www.lls.com |
| Peterborough, England | WWW Play: http://www.ruffle.me.uk |
--------------------------------------------------------------------
------------------------------------------------------------------------------
How ServiceNow helps IT people transform IT departments:
1. Consolidate legacy IT systems to a single system of record for IT
2. Standardize and globalize service processes across IT
3. Implement zero-touch automation to replace manual, redundant tasks
http://pubads.g.doubleclick.net/gampad/clk?id=51271111&iu=/4140/ostg.clktrk
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
