After a couple of hours trying to troubleshoot this, I am reaching to to the experts! I was setting up to cut a job. I ran it, cutting air, and decided to check/set the tool offsets. Somewhere in doing this, I got the following error:
Near line 74 of /home/eagle/linuxcnc/nc_files/SD_0910DRW01_new.ngc Radius to end of arc differs from radius to start: start=(X0.8794,Y0.7247) center=(X07778,Y0.5310) end=(X0.9966,Y0.3372) r1=0.2187 r2=0.2923 abs_err=0.07359 rel_err=25.1750% I am attaching the ngc file , but I don't think it is the source of the problem. I tried opening an earlier version that I used to successfully cut parts with back in August, and it gives a similar error now. Also when I dismiss the error and try to run the program, now I am getting "Z axis will exceed positive limit" when it comes to the third tool change, but I can move Z to the top, then restart from just before the tool change, and it will continue on to the next tool change. Maybe I botched up the tool table. Did I somehow get some other compensation turned on that is not obvious? Tired & frustrated at this point. Thank you for any help!! --J. Ray Mitchell Jr. jrmitche...@gmail.com “Truth is treason in the Empire of Lies.” — Ron Paul
SD_0910_DRW01_new1..ngc
Description: Binary data
------------------------------------------------------------------------------ October Webinars: Code for Performance Free Intel webinars can help you accelerate application performance. Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from the latest Intel processors and coprocessors. See abstracts and register > http://pubads.g.doubleclick.net/gampad/clk?id=60135031&iu=/4140/ostg.clktrk
_______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
