Florian, I believe Andy is correct. With your kins description you should be able to put the .1 offset in the A and B axis registers and correct the machine to position the block in alignment with the X and Y axes. thanks Stuart
On Tue, Aug 19, 2014 at 8:47 AM, andy pugh <[email protected]> wrote: > On 19 August 2014 14:27, Florian Rist <[email protected]> wrote: > > Now I mount the cube on the machine, after touching off it turns out > > that its 0.1 mm off in XYZ and turned and tilted by 0.1°. > > > > How to compensate this misalignment? > > My first guess would be to touch-off the B axis of your coordinate > system to 0.1 degrees and leave the CAM untouched... > > Depending on your kins this might or might not work. > > -- > atp > If you can't fix it, you don't own it. > http://www.ifixit.com/Manifesto > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Addressee is the intended audience. If you are not the addressee then my consent is not given for you to read this email furthermore it is my wish you would close this without saving or reading, and cease and desist from saving or opening my private correspondence. Thank you for honoring my wish. ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
