From: John Alexander Stewart Sent: 22 August 2014 14:29 Subject: Re: [Emc-users] G540, 5i25, missing steps, once again.
>> Ben, Riccardo; >> Maybe I have to re-think this issue on my G540. Been off doing other things recently, so no more work done on my mill. >> Q: no documents close by, so maybe a dumb question. How did you invert the step outputs? Andy has got in before me - but: setp hm2_5i25.0.gpio.xxx.invert_output true where xxx is the pin number for the stepgen step output. >> Q2: What timing parameters are you using? (steplen, stepspace, dirhold, dirsetup) 2000, 2000, 700, 700 - these are probably a bit higher than is actually needed - but allow a high enough step rate for my machine. Good luck. Ben ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that matters. http://tv.slashdot.org/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
