Thanks! I got commuciation between linuxcnc and my development board. Now I just have to figure out what linuxcnc send to get things done and what it expect back.
Best regards Nicklas Karlsson On Thu, 21 Aug 2014 02:00:31 +0200 Michael Haberler <[email protected]> wrote: > > Am 20.08.2014 um 19:04 schrieb Karlsson & Wang > <[email protected]>: > > > I am trying to use Modbus to talk to a card vi TCP which I built myself. I > > work as a software developer but are not familiar with the protocol, do > > anyone which registers or what it is called are used for what? > > search for 'TOSVERT VF-S11 Communications Function Instruction Manual' which > lists every bit you never were interested in;) > > -m > > > > > Nicklas Karlsson > > > > > > On Wed, 20 Aug 2014 16:13:51 +0300 > > Andrew <[email protected]> wrote: > > > >> Hello! > >> > >> I'm trying to connect my Toshiba VFD to LinuxCNC > >> http://linuxcnc.org/docs/html/drivers/VFS11.html > >> I made the interface according to Michael's diagram. > >> But there's no response from the VFD on pin 3, I checked it with my > >> O-scope. Though there's a signal on pin 5 when I try to connect with > >> Toshiba program. > >> Should I set some parameters on the VFD to see it answering? > >> > >> Thanks! ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that matters. http://tv.slashdot.org/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
