On 10/25/2014 07:12 PM, TJoseph Powderly wrote: > On 10/25/2014 09:05 PM, Ed wrote: >> On 10/25/2014 07:29 PM, Kirk Wallace wrote: >>> My Shizuoka mill has a pneumatic valve block with a Versa valve (for the >>> tool arm in/out) that looks just like this one: >>> http://www.ebay.com/itm/161456516453 >>> >>> The seals have hardened and need to be replaced. I can find the o-rings >>> and the X-rings. BTW here: >>> http://www.theoringstore.com/ >>> >>> But I haven't been able to find the u-ring seals that are on the ends of >>> the shuttle. Like this: >>> http://www.theoringstore.com/index.php?main_page=index&cPath=172_997_1011 >>> >>> Has anyone worked on these and knows which part to get? >>> >>> Thank you. >>> >>> >> >> When you say shuttle do you mean piston of the cylinder? >> >> I deal a lot in seals of that type, get me: >> >> Seal OD (bore of cyl ) >> Seal ID (diameter at bottom of groove) >> Seal width >> >> Ed. ... snip
> and note any reinforcement ( some cup seals have metal bands or ring > springs in addition to the soft bit ) > oh and if you use any lube in the air (viton vs butyl vs rubber can react ) > pix is always good > tomp tjtr33 Thank you Ed and Tom. I'll post pictures and dimensions tomorrow morning. I recall the seal being 1" OD, .75" ID and .103" wide, but I'll make sure before I post the pictures. Instead of shuttle, I think I meant to call it a bobbin which actually may be a hydraulics term. The valve body has a .43" diameter rod which has a short 1" diameter piston screwed to each end. Each piston is driven by a solenoid. I need the two piston seals. -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/ ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users