I should add that with this config:
GLADEVCP = EMCO120p.ui -d
EMBED_TAB_NAME=Cycles
EMBED_TAB_COMMAND=halcmd loadusr -Wn gladevcp gladevcp -c gladevcp -u
lathehandler.py -x {XID} lathemacro.ui
I get this message when Axis comes up and while my side panel is there and
works, the tab is empty:
LINUXCNC - 2.7.0~pre6
Machine configuration directory is
'/home/tom/linuxcnc/configs/EMCOturn120p-glade'
Machine configuration file is 'EMCOturn120pGlade.ini'
Starting LinuxCNC...
.
Found file:./EMCOturn120pGlade.hal
Found file:./custom.hal
spindle-vfd: device='/dev/ttyS0', baud=9600, parity='N', bits=8,
stopbits=2, address=1, enabled=0
INFO CLASSICLADDER- No ladder GUI requested-Realtime runs till HAL closes.
Toolerator3000 Firmware Version: Toolerator 3000 version 1.3 Burping Badger
Xlib.protocol.request.QueryExtension
Xlib.protocol.request.QueryExtension
Waiting for component 'gladevcp' to become
ready./home/tom/linuxcnc-dev/bin/gladevcp:185: GtkWarning: GtkSpinButton:
setting an adjustment with non-zero page size is deprecated
builder.add_from_file(xmlname)
Waiting for component 'gladevcp' to become ready.
/home/tom/linuxcnc-dev/bin/gladevcp:185: GtkWarning:
IA__gtk_radio_button_set_group: assertion `!g_slist_find (group,
radio_button)' failed
builder.add_from_file(xmlname)
HAL: ERROR: duplicate component name 'gladevcp'
*** GLADE VCP ERROR: Asking for a HAL component using a name that
already exists.
/home/tom/linuxcnc-dev/bin/gladevcp:295: GtkWarning:
gtk_widget_size_allocate(): attempt to allocate widget with width -5 and
height 15
gtk.main()
------------------------------------------------------------------------------
Monitor 25 network devices or servers for free with OpManager!
OpManager is web-based network management software that monitors
network devices and physical & virtual servers, alerts via email & sms
for fault. Monitor 25 devices for free with no restriction. Download now
http://ad.doubleclick.net/ddm/clk/292181274;119417398;o
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
