did you physically power cycle the machine? on-off-on? sam
On 8/27/2015 1:13 PM, Viesturs Lācis wrote: > Hello! > > I have a spare 5i25 board that finally has found a project to be used in. > I downloaded 5i25.zip file from Mesa webpage, extracted the file and > found that 5i25_g540x2 has the required pinout for the project. I > copied 5i25_g540x2.bit file to the folder, where mesaflash binary is > located. In terminal I ran these commands: > cd /home/vie/Desktop/5i25/utils/linux > ./mesaflash --device 5I25 --write 5i25_g540x2.bit > ./mesaflash --device 5I25 --verify 5i25_g540x2.bit > It displayed that verification was succesful. > > Now I am trying to adjust hm2-stepper sample config of 5i23 board to > work with 5i25. For that I have changed the beginning of INI file to > remove the reference to firmware file, so now it looks like this: > [HOSTMOT2] > DRIVER=hm2_pci > BOARD=5i25 > CONFIG="num_encoders=0 num_pwmgens=0 num_stepgens=4" > > The thing is that at startup LinuxCNC (version 2.6.9) complains about > any stepgen-related HAL pins. I commented _all_ of them out and then > LinuxCNC starts up and in HalShow I see that there are no stepgens > loaded. I see gpio pins, watchdog pin and 2 LED pins under hm2_5i25. > > I tried old backups of configs from earlier projects that also used > 5i25 boards and the result is the same > > I would appreciate any suggestions, what exactly am I missing. > > Viesturs > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users