On Tue, Jan 05, 2016 at 10:12:15AM +0000, andy pugh wrote: > > Re-homing the rotary would reset the absolute position. > There are HAL pins to home each axis. (halui.joint.N.home bit in) > You can drive a bit pin from G-code. > So I think it could be done, but it seems like a kludge.
You can't home while gcode is running; you have to stop and switch to manual mode. I think dewey has found a fine answer: remove the lines from the ini and don't worry. If someone cares about the difference between MAXDOUBLE and 1e99, we could sure change it. ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
