I have the wireless pendant button triggering a probe cycle in an .ngc.
Problem is, IF the cycle ends without tripping the probe (user error),
Axis UI ends up switching to MDI tab, and all the pendant function is
for Manual Control tab. So it disables the pendant until you can get
back to the PC and fix it by clicking back to Manual Control tab. Why
does it end up in MDI tab, and how can make LinuxCNC end up back in the
Manual Control tab?
.ngc code below:
<pre>
o100 sub
#1 = #[5203 + [20 * #5220] ]
G38.3 F50 Z[-6.5-#1]
G10 L2 P0 Z1.826
o101 if [#5070 EQ 1]
G10 L20 P0 Z1.826
G1 Z1.93 F3
G38.3 F3 Z[1.6]
G10 L20 P0 Z1.826
G0 Z2.5
o101 else
G53 G0 Z0
(debug, FAILED TO FIND PROBE)
o101 endif
o100 endsub
</pre>
Thanks,
Danny
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
