OK, I got linuxcnc-dev installed on 2.5 and the hal comps compiled. All I needed to do was add the apt source "deb http://linuxcnc.org/ lucid base linuxcnc2.5"
For some reason the preexisting apt lines were for emc2.4, even though I installed the 2.5 image. Odd... Thanks all, I am leaning very slowly but surely! Off to try the comps in PP now. Kurt On Mon, Feb 27, 2017 at 12:14 PM, Kurt Jacobson <kurtcjacob...@gmail.com> wrote: > Hello all, > > I am trying to compile some HAL components for PathPilot. I though the > best thing to do would be to compile them on LCNC 2.5.0 running on Ubuntu > 10.04 with 2.6.32-122-rtai since that appears to match what PathPilot is > running on, and them transfer them over to PathPilot. > > I have installed LCNC 2.5.0 from one of the old images just fine. The > problem is I cannot seem to install linuxcnc-dev, which I need to compile > the HAL components, correct? > > I have tried saying > > sudo apt-get install linuxcnc-dev > > sudo apt-get install emc-dev > > sudo apt-get install emc2-dev > > all to no avail. They get right back to me and say they cannot find the > package. > > I also tried installing the dev packages from Synaptic, but can't fine > them there either. > > I am a Linux noob so I have a feeling I missing something simple, any > pointer in the right direction would be greatly appreciated. > > Thank you all, > > Kurt > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
