and why not continue to use ubuntu 10.04?
I suspect that your ram is a bit slow ... try to buy new one more fast ex. 1333Mhz type and 2Gb .... regards giorgio ________________________________ Da: Todd Zuercher <[email protected]> Inviato: mercoledì 10 maggio 2017 18.22 A: Linuxcnc-Users Oggetto: [Emc-users] Installing On Older Computer Is there a trick to installing Linuxcnc/Wheezy on an older single core computer? I have a machine that has been happily running Linuxcnc for some time on an older Linuxcnc Ubuntu 10,04 install. It is an older P4 2.8gHz cpu (single core) with 1G memory and works reasonably well with Lucid. This PC is a little bit special in that it has some ISA slots on the motherboard and 1 ISA card is used by Linuxcnc to interface with the machine. I have tried several times to test or install the newer Linuxcnc/Wheezy iso. But it boots and runs painfully slow, and neither the latency tests or Linuxcnc will open. Trying to start Linuxcnc from the command line tells me nothing. Any ideas why this machine refuses to work with the newer version? -- ======================================== Todd Zuercher mailto:[email protected] ======================================== ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
