Hi
I have to replace my lathe drive and the one I have does not have a 10v
source for the 7i76 card produce the 0 - 10v signal.
Is there a clever way to drive this with with 7i76.
-----------------------------
Regards / Groete
Marius D. Liebenberg
+27 82 698 3251
+27 12 743 6064
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
