That was the idea. ----- Original Message ----- From: BRIAN GLACKIN <[email protected]> To: Enhanced Machine Controller (EMC) <[email protected]> Sent: Fri, 02 Feb 2018 12:50:03 -0500 (EST) Subject: Re: [Emc-users] Dynamic Soft Limits?
Are you going to have multiple tools working within the same work envelope on the same piece? On Fri, Feb 2, 2018 at 11:47 AM, Andrew <[email protected]> wrote: > 2018-02-02 16:49 GMT+02:00 Todd Zuercher: > > > For example X can travel from 0-100, and U can travel from 20-120, U can > > be located in any position in its travel so long as it is greater than X, > > and X can only go to a position less than U. > > > > Might be a job for inihal pins ini.N.ini_limit and ini.N.max_limit. > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users -- ======================================== Todd Zuercher mailto:[email protected] ======================================== ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
