Greetings all; As you are aware by now, I try to keep my 2.8 pre's uptodate, 2 to 4x a week.
At the initial startup, I am seeing this logged: twopass: sourcing: /tmp/GO704fast.hal.tmp twopass: deleting: /tmp/GO704fast.hal.tmp twopass: pass1:END note: MAXV max: 2.500 units/sec 150.000 units/min note: LJOG max: 2.500 units/sec 150.000 units/min note: LJOG default: 1.500 units/sec 90.000 units/min note: AJOG max: 50.000 units/sec 3000.000 units/min note: AJOG default: 15.000 units/sec 900.000 units/min Can anyone decode this re the MAXV, and LJOG's as to which axis its advising me of? AJOG seems obvious enough, and is because I am still fine tuning that axis, have just re-enabled it a month ago. And its trying to convince me that I need a more precise table (Its a 4", made in india) and needs a nema 42 motor if expected to move while cutting. I had a heck of a time making that kreg style drill bit, 3/4" OD that I needed to anchor the guard rail posts for the wheel chair ramp in the front deck, and am still half stove up from the muscle required to drive it 4" deep in the sides of a treated 4x4. FWIW, the accel of the rotary is still rather leasurely, at least a second to get that 230 oz/in nema 23 up to around 500 motor revs. Or to stop it at the end of a g0 move. I gotta get a bigger, far more precisely made table. But where would I put a harmonic driven table on a G0704? They are huge. -- Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
