Sorry. Something went strange here. This was never meant for this list > -----Original Message----- > From: John Dammeyer [mailto:jo...@autoartisans.com] > Sent: April-20-18 3:08 PM > To: 'Enhanced Machine Controller (EMC)' > Subject: Re: [Emc-users] Mesa choices > > Hi Christian, > There are no bare boards without parts on them. > > The board is mostly surface mount parts. The through hole parts are not > installed. The kit without the micro-stepper parts will cost you $200 Cdn. > Soldering time is about 3 to 5 hours. Best to use 22g rosin core solder to > get good bonding with the leads of the switches etc. > > John > > > > -----Original Message----- > > From: jeremy youngs [mailto:jcyoung...@gmail.com] > > Sent: April-20-18 1:14 PM > > To: Enhanced Machine Controller (EMC) > > Subject: Re: [Emc-users] Mesa choices > > > > 7i90 and cable should be here tomorrow, timing belts and pulleys on the > > way > > too. I'm going to see if I can get a pinout on these renco encoders , I > > figure once the mess card is hooked up I can count the pulse in one > > rotation and go from there. Pretty busy the next few days so it will be > mid > > week before I really get to focus energy on this. Exciting times, sure > more > > questions to come. I'm going to get a dead tree copy if the lcnc manual > and > > the integrator manual done up in the next week or so. TTYL > > > ---------------------------------------------------------------------------- > -- > > Check out the vibrant tech community on one of the world's most > > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > ---------------------------------------------------------------------------- -- > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users