On 11 July 2018 at 23:01, Joe Hildreth <[email protected]> wrote:
> I think the driver works just fine. I agree that the control port is > bidirectional. I would think that the entire control group of pins is set to > either output (for modes in and out) and set to input (for mode x). I think you are right. use_control_in is only set to 1 for X mode https://github.com/LinuxCNC/linuxcnc/blob/master/src/hal/drivers/hal_parport.c#L540 -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
