Thanks Peter and Andy for your input. I don't put much trust in the internal hardware, no documentation what so ever except for the spindle VFD. There is a retrofitted machine on eBay, but too many differences. The servos looks the same and is specified as "GR80x80 Asto 24V von Dunkermotoren". My controller says 60 V on the data sign. I can take some photos of a driver but I rather do the effort to add some new and known hardware than trying to run on old unknown.
On Sat, Jul 14, 2018 at 1:36 AM andy pugh <[email protected]> wrote: > On 14 July 2018 at 00:18, Peter C. Wallace <[email protected]> wrote: > > > I believe you have the same advantages with the STMBL drives > > > > A basic step/dir drive would be easier to setup however... > > STMBL can do step/dir too. > > It's basically a servo drive with a HAL. You can freely combine motor > types, feedback types and control types. > > But it works best of all as a Mesa Smart-Serial slave. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1916 > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
