Peter, Thank you. I'll be in touch. I need to address a number of other issues before I can get back to this now. John
> -----Original Message----- > From: Peter C. Wallace [mailto:[email protected]] > Sent: June-23-19 6:22 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Dual boot for WIN-XP and LinuxCNC > > On Sun, 23 Jun 2019, John Dammeyer wrote: > > > Date: Sun, 23 Jun 2019 17:45:11 -0700 > > From: John Dammeyer <[email protected]> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <[email protected]> > > To: "'Enhanced Machine Controller (EMC)'" <emc- > [email protected]> > > Subject: Re: [Emc-users] Dual boot for WIN-XP and LinuxCNC > > > > So if I want Xstep on pin 2 and xdir on pin 3 then this? > > > > 1 0 IOPort None > > 14 1 IOPort None 0 > > 2 2 IOPort StepGen 0 Step/Table1 (Out) > > 15 3 IOPort None > > 3 4 IOPort StepGen 0 Dir/Table2 (Out) > > > > The ribbon cable pin 1 is an output for Enable from Linux. > > I'm guessing I'd have to set pin 17 (or is it pin 8 from the manual to > correspond to pin 7 on the DB-25). > > > > Still confused. > > John > > > > > The .pin file for the 7I92 has DB25 pin numbera in the first column and GPIO > number in the second > > Note the both the G540 and the 5ABOB pinouts are: > > 2 step > 3 dir > 4 step > 5 dir > > etc > > > > > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
