> On Tue, 6 Aug 2019 at 05:13, Nicklas Karlsson <[email protected]> > wrote: > > > I found it useful to start capture os sample signal and quit then enough > > samples have been taken with the enable signal. Difference from today is > > sampling is stopped at negative flank of enable signal so that how many > > samples are taken may be controlled from Linuxcnc instead of command line > > which is useful then a series of commands should be record. Change is > > simple and an extra option for example "-q" to sampler_usr to enable this > > behaviour only then needed might be a good solution. If I make a patch > > would anyone else think it would be good to add this? > > > Is there any real disadvantage to leaving sampler loaded but disabled? (If > I understand your suggestion properly)
Did not think about it, quit manually is possible so no serious disadvantage unless started from other software then it is useful because otherwise it's hard to tell then done. Should think about it and then I used it for a while ut might be the right time. Nicklas Karlsson _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
