On Fri, 2019-09-20 at 02:05 -0400, Gene Heskett wrote:
> On Friday 20 September 2019 00:35:58 Valerio Bellizzomi wrote:
> 
> > Is it compatible with Linuxcnc ?
> >
> > http://www.triplc.com/documents/SmartTILE_Product_DataSheet.pdf
> >
> Yes and No. Yes if someone writes the interface, and No, its not fast 
> enough, nor wide enough unless 2 or 3 are used as I only see 3 stepgen 
> kits, 3 encoders, notably  without indexes, And a pwm to run the spindle 
> with. We have already more capable boards available from several 
> vendors.


I have this one https://mesaus.com/product/5i25-7i76-kit/

But I would like a board with closed-loop motor control, encoders and
ethernet.


> What I'd see it as, is further fragmentaion of an already fragmented 
> market. What I'd really like to see is a micro sized version of the 
> D525MW motherboard with a 50 MHz SPI interface and no pci.  This isn't 
> it.
> >
> >
> >
> > _______________________________________________
> > Emc-users mailing list
> > Emc-users@lists.sourceforge.net
> > https://lists.sourceforge.net/lists/listinfo/emc-users
> 
> 
> Cheers, Gene Heskett






_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to