Finally got things running well today. According to scale then moving to point at standstill accuracy is around a few micrometers for table and a few times more in "Z" direction. This corresponds to a few encoder pulses for table and a few times more for "Z" direction. Did not check check then moving but expect a lot less accuracy then at move, it was a little bit cold but not to bad, another time it was dark and then open door to get light inside weather also came in, wind and also some snow. Then there is of course plenty of other inaccuracies, driving belt, screw, tool bending, ...
Anyone here have any experience what accuracy is required then machining parts? Regards Nicklas Karlsson _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users