Hi,
I have the following problem:
Linuxcnc 2.9 pre xxx
MESA 7i90HD + 7i33 + 3 analog servo (ELMO ISP)
If I am running a code and I press ESC button to stop the execute, then
after pressing the button, the axes move again for approx. 15-20 mm.
The enable signal is not removed from the servo drives, so in principle
they should hold a position.
What could be the problem?
Regards, Csaba
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users