On Wednesday 03 June 2020 12:32:55 andy pugh wrote: > On Wed, 3 Jun 2020 at 17:20, Gene Heskett <ghesk...@shentel.net> > wrote: > > And I just found something else that is a show stopper. That isn't > "raft" > > > thats blocking the nut entry! it left a tongue the width of the nut, > > and about .4mm thick, centered in the height of the nut channel, and > > blocking the nut insert hole all the way to the bottom. And it > > wasn't in the preview, that was good. > > It is probably in the layer-by-later preview (which you control by > sliding two points up and down a line) > And it is probably a support. It _should_ ping out as there is a gap > left on top of support to prevent prober adhesion. > Het a screwdriver in there and start levering.
I've done some of that, to no avail. It seems to be anchored quite solidly at a point out from where the nut would be. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users