On Mon, 20 Jul 2020 at 10:40, Gene Heskett <[email protected]> wrote:
> Some, but at much higher resolutions than what is being laid down in > plastic. My point is that .stl's obtained from non-openscad src's, are > reproduced much more accurately. Openscad's tooth profile for an XL > pulley is good. Any smaller teeth dissolves into a 20% fill with almost > zero resemblance to the tooth you can see in cura. That doesn't make any sense. If the model looks good in OpenSCAD and the G-code looks good in Cura then there is no way that it can be OpenSCADs fault. Those two inspection points are before the STL is created and after it has been used. (the Cura preview is a G-code preview) -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1912 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
