Running LinuxCNC 2.8 on a parallel port setup. Not sure what the minor number is, installed a few months ago.
Gcode was from Vectric Vcarve 10.5 using the LinuxCNC post processor. I tried the Vectric LinuxCNC post processor yesterday to see if it was smoother than their EMC G61 post processor. During the run I got a pop up error message that repeated with just the ID number changing. Message: Tried to set invalid pose in tpAddCurrentPos on id 1347!disp is nan, nan, nan The message appeared twice for each instance and repeated with different (increasing) numbers. Any pointers as to where to start looking or is this something to just ignore? Dave _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users