I see 29 on 9/22 7 on 9/23 1 on 9/25 3 on 9/26
I saw the same thing on 7/27
Scott
On Saturday, September 26, 2020, 11:45:02 AM CDT, John Dammeyer
<[email protected]> wrote:
The forum archives show no messages for the 24th, my message on the 25th and
yours on the 26th.
So perhaps everyone is COIVD-19 locked down inside their house and can't make
it out to the shop or their PC?
John
> -----Original Message-----
> From: dave engvall [mailto:[email protected]]
> Sent: September-26-20 9:29 AM
> To: [email protected]
> Subject: Re: [Emc-users] Small project and test email.
>
> I just checked the forum and it is alive and well. Something is screwed
> up with the list.
> Dave
>
>
> On 9/24/20 11:05 PM, John Dammeyer wrote:
> > For me the list has been quiet but checking the forum web page there have
> > been messages up to 23SEP2020. Not sure why I'm
> suddenly not receiving messages so I thought I'd try and post what I've been
> up to.
> >
> > John
> >
> >
> >
> > I needed a matrix to guide a razor blade to cut Silpad into 0.375" x 0.55"
> > pieces. But how to repeatedly measure 0.55"?
> >
> > Machine something of course. Here's the end product in plywood. Did use
> > metal engraving bit and metal mill.
> > http://www.autoartisans.com/mill/SilPad/SilPadMatrix.jpg
> >
> > Start with an AlibreDrawing with lines for engraving.
> > http://www.autoartisans.com/mill/SilPad/SilPadMatrixDrawing.jpg
> >
> > Then create the G-Code and get LinuxCNC, this time running on a Raspberry
> > Pi4, to control the mill.
> > http://www.autoartisans.com/mill/SilPad/SilPadMatrixLinuxCNC.jpg
> >
> > And away we go.
> > http://www.autoartisans.com/mill/SilPad/SilPadMatrixEngraving.jpg
> >
> > The end result with a coat of shellac looks good but the lines are hard to
> > see.
> > http://www.autoartisans.com/mill/SilPad/SilPadMatrixShellaced.jpg
> >
> > So after a few more coats of shellac and some sanding I sprayed a blue
> > coat. Then after it had a short while to dry a bit I used a
> paper towel with laquer thinner to wipe off the blue coating but leave the
> paint in the lines.
> >
> > Next step. Cut the silpad into the rectangles and that worked really well.
> > cid:[email protected]
> >
> >
> > John
> >
> >
> >
> > _______________________________________________
> > Emc-users mailing list
> > [email protected]
> > https://lists.sourceforge.net/lists/listinfo/emc-users
>
>
> _______________________________________________
> Emc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
