Greetings all; I am currently setup to use a 2nd pwmgen in a 5i25, which should come out on the bob plugged onto p2 at pin 5 dir as dir, and pin 6 for the pwm.
I am not going to use the dir because these h-bridges need both a fwd and a reverse drive to cause the top half of the h-bridge to be the fwd or rev switch. But I cannot find the pwm that s/b on pin 6. Those 2 pins are not visible in either the halmeter or halscope input selector menu. They should be seen at gpio's 25 and 26, pin 5 and 6 on a bob. Short of a bad cable or a blown 5i25, where can it be found for troubleshooting observation? Either by halscope or by a real scope? Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users