Can't be all that bad. He has a Gingery Lathe .. heh heh... > -----Original Message----- > From: Bari [mailto:[email protected]] > Sent: January-06-21 6:27 PM > To: [email protected] > Subject: Re: [Emc-users] 4th axis engraving > > Check out G-code Ripper > > http://www.scorchworks.com/index.html > > Read, Scale, Rotate, Split, Wrap G-Code > > http://www.scorchworks.com/Gcoderipper/gcoderipper.html#documentation > > On 1/6/21 4:02 PM, andrew beck wrote: > > Hey everyone > > > > I have a job to do engraving the od of a wheel. I currently have a 4th > > axis but haven't bolted a motor on it. I can suss this part though. And I > > use fusion360 for cam. > > > > I have never done 4th axis work before. And don't even know if anyone has > > a linuxcnc post processor set up. > > > > If anyone out there has done this I would love to hear from you. I have > > about a week to get this working. > > > > Regards > > > > Andrew > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
