> > Ahh, good point! It would be nice to be able to explicitly specify a > spindle angle too, but that's a good workaround.
I always thought about having a way to offet the index pulse. But since most people use hardware for encoder counting, I suspect the solution should be right there in the hardware. El mié, 20 ene 2021 a las 15:58, Robert Ellenberg (<rwe...@gmail.com>) escribió: > Ahh, good point! It would be nice to be able to explicitly specify a > spindle angle too, but that's a good workaround. > > On Wed, Jan 20, 2021, 1:50 PM Andy Pugh <bodge...@gmail.com> wrote: > > > > > > > > On 20 Jan 2021, at 18:14, Robert Ellenberg <rwe...@gmail.com> wrote: > > > > > > > > > Note that multi-start threading is not currently possible > > > > > > You can do it by offsetting the start point. > > (If there is room) > > > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users