On Tuesday 02 March 2021 03:59:49 andy pugh wrote: > On Mon, 1 Mar 2021 at 04:24, Feral Engineer <theferalengin...@gmail.com> wrote: > > z axis utilize a mechanical limit switch to latch home position, but > > then each axis has a pnp proximity sensor that triggers the actual > > home position > > Are both the switch and the PNP on at the same time? > Is the PNP "long" enough to serve as a limit switch all by itself? > > If it is, then you can use AND logic, either in the HAL or, as > suggested by R Jollivert, in the physical wiring. > > If the PNP pulse is too short to serve as a home switch then you could > try using HOME_INDEX_NO_ENCODER_RESET
> http://linuxcnc.org/docs/devel/html/config/ini-config.html#_joint__lt_ >num_gt_section Though that only exists in Master. Did I spot a spelling error already? last line above the [FILTER] section reads: HELP_FILE = tklinucnc.txt - Path to help file. Shouldn't that be tklinuxcnc.txt? :) 25 pages to print, but worthwhile, lots of new info in that, thank you very much, Andy. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
