Would you share your machine files? I haven't set up 5x kinematics in lcnc before and I'm curious of what the user files look like
Phil T. The Feral Engineer Check out my LinuxCNC tutorials, machine builds and other antics at www.youtube.com/c/theferalengineer Help support my channel efforts and coffee addiction: www.patreon.com/theferalengineer On Sun, Jun 20, 2021, 5:18 PM Tomaz T. <[email protected]> wrote: > I'm using slightly modified 5axiskins, that means g-code is for tool > center point. > > > >Are you using kinematic support and tool center point control in LinuxCNC > >or just relying on cam software to do the trajectory calculations from > tool > >tip to rotational center? > > >Phil T. > >The Feral Engineer > > > >Check out my LinuxCNC tutorials, machine builds and other antics at > >www.youtube.com/c/theferalengineer< > http://www.youtube.com/c/theferalengineer> > > > >Help support my channel efforts and coffee addiction: > >www.patreon.com/theferalengineer<http://www.patreon.com/theferalengineer> > > > >On Sun, Jun 20, 2021, 3:35 PM Tomaz T. <[email protected]> wrote: > > > >> Recent project done on my DIY 5-axis, controlled by LinuxCNC, just to > >> encourage if anyone taking similar path: > >> > >> https://www.youtube.com/watch?v=TobQG2T7YV4 > >> > >> Regards! > >> > >> _______________________________________________ > >> Emc-users mailing list > >> [email protected] > >> https://lists.sourceforge.net/lists/listinfo/emc-users > >> > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
