Well, I suspect what Andrew was asking was whether Native CAM will generate toolpaths and g-code for lathes. There seems to be a lot of discussion about nativecam on the forum, and I see mention of lathe mode, so I think "yes".
-- Ralph On Jan 27, 2022 1:07 PM, fxkl47BF--- via Emc-users <emc-users@lists.sourceforge.net> wrote: CAUTION: This email originated from outside the Walla Walla University email system. On Fri, 28 Jan 2022, andrew beck wrote: > Hey can you use native cam on a lathe?? > > On Fri, 28 Jan 2022, 07:03 fxkl47BF--- via Emc-users, > <emc-users@lists.sourceforge.net> wrote: > I started playing with nativecam. > It's pretty neat. > With linuxcnc running is there a way to "hide" the nativecam interface? As far as I know it can only be used on a computer. _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://nam12.safelinks.protection.outlook.com/?url=https%3A%2F%2Flists.sourceforge.net%2Flists%2Flistinfo%2Femc-users&data=04%7C01%7Cralph.stirling%40wallawalla.edu%7Cdb4ee29221b54a0e6f7208d9e1d8fbf7%7Cd958f048e43142779c8debfb75e7aa64%7C0%7C0%7C637789144321517837%7CUnknown%7CTWFpbGZsb3d8eyJWIjoiMC4wLjAwMDAiLCJQIjoiV2luMzIiLCJBTiI6Ik1haWwiLCJXVCI6Mn0%3D%7C3000&sdata=iEEywy%2BST33gFqQx4vNbrgMMm4skbxbXUrSzovt%2BCNo%3D&reserved=0 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users