On Tuesday, March 1, 2022 11:21:16 AM EST Peter C. Wallace wrote: > On Mon, 28 Feb 2022, gene heskett wrote: > > Date: Mon, 28 Feb 2022 20:11:35 -0500 > > From: gene heskett <ghesk...@shentel.net> > > Reply-To: "Enhanced Machine Controller (EMC)" > > > > <emc-users@lists.sourceforge.net> > > > > To: "Enhanced Machine Controller (EMC)" > > <emc-users@lists.sourceforge.net> Subject: [Emc-users] Q for Peter? > > > > Greetings Peter; > > > > The 7i76 has, I recall reading, the ability to do analog to digital > > conversions on the first 4 of its inputs. But the full scale range is > > 36 volts if I recall right. I don't recall the bit range, though, > > whether its 8 bit, or 16. > > > > Would it be possible to lower the full scale range to 0-5 volts with > > a > > firmware change? > > > > I have acquired a couple pressure sensors rated at 0-10 psi with a 5 > > volt input, .5 to 4.5 volt outbut and want to use them to monitor, > > and control the speed by pwm means as the mister(s) only need 3 or 4 > > psi to do their job if the nozzle is close enough to the cutting > > face. Inch or so. > > > > Thanks Peter, take care and stay well. > > > > Cheers, Gene Heskett. > > Not with firmware but you could replace the low side resistor network > on the first 4 inputs with say 22K (was 1.8K) to get about a 5V full > scale range
And those are I assume, surface mount grain of sand? I'll have to look, and my eyes are starting to fade. Thanks Peter, stay well now. > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. Cheers, Gene Heskett. -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author, 1940) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users