A while back I swapped out my accurite glass scales on x and y (manual
mill) for 5 um Chinese ones because my DRO was going bad. The accurite
ones are better but were not compatible with a Chinese DRO. Still very
good to passable without adding the builtin comp. Fixes the problem of
counting turns. ;-) And I might say adds confidence to the job. I
actually did it because I wanted a check on the, still in progress,
project of having stepper-servos on all three axes.
More later, maybe much later.
Dave
On 3/18/22 7:32 AM, Sam Sokolik wrote:
Thought about it... :)
On Fri, Mar 18, 2022 at 4:50 AM andy pugh <bodge...@gmail.com> wrote:
On Fri, 18 Mar 2022 at 03:11, Sam Sokolik <samco...@gmail.com> wrote:
https://www.youtube.com/watch?v=mes7pFZ90Fg
If you fitted linear scales you could potentially have manual rapids
by disengaging the half-nuts.
--
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1912
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users