Hi All,
I have a 7i92 7i77 combo driving our mill. I flashed it with servo stuff
when I installed it. My son and I had been milling parts for a few days.
This morning when I booted up I got a strange error and by power cycling
the mesa boards, everything came up fine. We were running for a few
hours and after a part and tool change we got a joint following error
and it turned out that no joint would move. After recycling the mesa
power I could move joints, but in less than a minute, errors, like
serial errors and timeout errors. So, tried it again and now I could not
bring Linuxcnc up. It got to:
hm2/hm2_7i92.0: registered
./hm2-servo7i77.hal:95: Pin 'hm2_7i92.0.7i77.0.0.output-10' does not exist
Shutting down and cleaning up LinuxCNC...
I have a feeling it is the 7i77 from what I've read, the serial port on
the board died, but I don't know how to check it. This setup has been
running fine for some 5 years.
So I was just going to order a new set of boards this morning, but they
are out of stock! I see there are other board that might work, but I'm
not sure.
Thanks for any help.
Best Dan.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
