The problems you are having aren't quite the same but coincidentally I am also having issues with the M6 remap and probing a tool with tool table zero length (drill in chuck) compared to a measured tool (end mill or 3mm tap in holder).
One time it works. The next time the drill bit is too high for the zero position. When it was only a tad off I didn't see the issue until the 3mm tap bottomed in the previously drilled hole and snapped. Other times it's clearly way too far away for zero. I think it has something to do with the G59.3 used in the m6remap.ngc when probing a tool on the tool setter. More when I figure out what is wrong. John > -----Original Message----- > From: Viesturs Lacis [mailto:viesturs.la...@gmail.com] > Sent: November 6, 2024 9:32 AM > To: Enhanced Machine Controller (EMC) > Subject: [Emc-users] M6 remap issues > > Hello! > > I am stuck with M6 remap in the final stage of the Biesse retrofit. > I suspect that not all of the mailing list readers are following the > forum and vice versa, so I will share a link to my post with more > detailed description: > https://www.forum.linuxcnc.org/10-advanced-configuration/54366-remap- > of-m6-not-working-correctly > > Any comments are appreciated. > > Viesturs > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
