Just found it on mesanet.com :) By the way, this is the exact same firmware the 7i95 comes when purchasing? The only change is that I can use HOME_USE_INDEX with the stepgens, right?
Thanks Peter! El mié, 26 feb 2025 a las 23:04, Leonardo Marsaglia (<[email protected]>) escribió: > Thanks Peter, > > Next question is, where can I download it? :) > > El mié, 26 feb 2025 a las 23:00, Peter Wallace (<[email protected]>) > escribió: > >> On Wed, 26 Feb 2025, Leonardo Marsaglia wrote: >> >> > Date: Wed, 26 Feb 2025 22:34:33 -0300 >> > From: Leonardo Marsaglia <[email protected]> >> > Reply-To: "Enhanced Machine Controller (EMC)" >> > <[email protected]> >> > To: "Enhanced Machine Controller (EMC)" < >> [email protected]> >> > Subject: [Emc-users] HOME_USE_INDEX with steppers on MESA 7i95 >> (Probably for >> > PCW) >> > >> > Hello all, >> > >> > I'm making an emergency retrofit on one of our lathes and I'm using a >> 7i95 >> > to drive the servo motors using in stepper mode. >> > >> > I plan to use HOME_USE_INDEX and it seems now it's supported for >> steppers >> > also, but I think I need to upgrade the firmware on my 7i95 to >> incorporate >> > this function. Is that right? >> > >> > Thanks a lot! >> >> >> Yes, you need 7i95sdid.bit firmware for a (plain) 7I95 >> and 7i95t_sdid.bin firmware for a 7I95T >> >> >> > >> > _______________________________________________ >> > Emc-users mailing list >> > [email protected] >> > https://lists.sourceforge.net/lists/listinfo/emc-users >> > >> >> Peter Wallace >> Mesa Electronics >> >> >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
