> > Basically it's a question of fitting, what version of the 7I80DB do you > have?
Sorry for that. I don't have any. I plan to purchase all the boards to retrofit a new machine. El lun, 10 nov 2025 a las 13:36, Peter Wallace (<[email protected]>) escribió: > On Mon, 10 Nov 2025, Leonardo Marsaglia wrote: > > > Date: Mon, 10 Nov 2025 13:05:54 -0300 > > From: Leonardo Marsaglia <[email protected]> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <[email protected]> > > To: "Enhanced Machine Controller (EMC)" <[email protected] > > > > Subject: Re: [Emc-users] Questions about Mesa cards > > > > Hi Peter, > > >> Yes, its possible to make "A" only encoders channels on a 7I89/FPGA card > >> set, what 7I80DB do you have and what other I/O is needed? > > > >My idea is the following: > > > > 7i80DB25 ---------> 7i89 > > ----------> 7i85s > > ----------> 7i74 ---------> 7i70 > > ---------> 7i72 > > > >Is this configuration ok? > > > > Basically it's a question of fitting, what version of the 7I80DB do you > have? > > > > > El lun, 10 nov 2025 a las 11:59, Peter Wallace (<[email protected]>) > escribiяя: > > > On Mon, 10 Nov 2025, Leonardo Marsaglia wrote: > > > > > Date: Mon, 10 Nov 2025 09:11:26 -0300 > > > From: Leonardo Marsaglia <[email protected]> > > > Reply-To: "Enhanced Machine Controller (EMC)" > > > <[email protected]> > > > To: "Enhanced Machine Controller (EMC)" < > [email protected] > > > > > > Subject: [Emc-users] Questions about Mesa cards > > > > > > Hi guys, I hope you are doing well > > > > > > I have a short question to define a setup > > > > > > For the 7i89, a while ago PCW told me that it could be possible to > make a > > > counter mode only firmware and use only the A channel encoder input > > since I > > > only want to sense frequency and not direction. This way I can have 24 > > > frequency counters in one board. Is this easily done via firmware > > > editing/upgrade? > > > > > > Thanks a lot for your help > > > > > > _______________________________________________ > > > Emc-users mailing list > > > [email protected] > > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > > > Yes, its possible to make "A" only encoders channels on a 7I89/FPGA card > > set, what 7I80DB do you have and what other I/O is needed? > > > > Peter Wallace > > Mesa Electronics > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > Peter Wallace > Mesa Electronics_______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
