Thanks Robert. 1:28AM here now. I'll check tomorrow what G's are set. I'm wondering if there is some sort of timeout in play. My rapid moves are 10 ipm and the uneven point where it stops might be due to not reaching the target in time so it stops but not with an error which is why it then goes downwards. John
> -----Original Message----- > From: Robert Schöftner [mailto:[email protected]] > Sent: December 7, 2025 12:53 AM > To: [email protected] > Subject: Re: [Emc-users] Accessing python hal valriables. > > Am Samstag, dem 06.12.2025 um 16:19 -0800 schrieb John Dammeyer: > > To add to this I can set the distance to 0.4" and then use the inner > > hole to find center.� That works but again the distance is smaller. > > I've attached two small photos.� Hopefully they come through. > > John > > Does this behaviour change with feed rate? Is it possible G64 is > active? If so you could try with G61 or G61.1 > > -- > Robert Sch�ftner <[email protected]> > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
